Skip to Content

DIY Pulldown Hanging Drying Rack-18

Then use your drill and pocket hole screws to attach (2) of the 21" pieces to (1) of the 24" pieces like so:

Leave a comment

Your email address will not be published. Required fields are marked *


    I decided to turn off comments on most of my posts because of the crazy comment spam. If you see a spot to leave a comment, please do. If you don't, you can hop over to my Instagram and leave a comment or send me a direct message. Thank you for visiting and reading!
    +++
    This blog's content is for entertainment purposes only and is not professional advice. By reading this blog and attempting to re-create any content shared on it, you assume all responsibility. Read my full Terms of Use here. Be safe out there!